Steps
1. Replace the speaker into the slot in the computer.
2. Route the speaker cable along the cable guides on the palmrest assembly.
NOTE:
While replacing the speakers, route the speaker cable into the routing channels along the bottom side of the
palmrest assembly.
Route the speaker cable over the LED board FFC and secure it in place with tape adhered to the palmrest and touchpad.
Next steps
1. Install the battery.
2. Install the base cover.
3. Install the microSD card.
4. Follow the procedure in after working inside your computer.
SmartCard reader
Removing the smart card reader
Prerequisites
1. Follow the procedure in before working inside your computer.
Removing and installing components
43
To Next Page
Loading...
