Dell Latitude 7370 - Installing the Coin Cell Battery; Removing the Smart Card Cage; Installing the Smart Card Cage

Installing the coin cell battery
1. Place the coin cell battery into the slot on the system board.
2. Connect the coin cell battery cable to the connector on the system board.
3. Connect the battery cable to the connector on the system board.
4. Install the:
a. base cover
5. Follow the procedure in After working inside your computer.
Removing the smart card cage
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the smart card cage:
a. Disconnect the smart card FFC cable [1,2].
b. Remove the screws that secure the smart card cage to the system board [3].
c. Lift the smart card cage from the system board [4].
Installing the smart card cage
1. Place the smart card cage on the system board.
2. Tighten the screw to secure the smart card cage to the computer.
3. Connect the smart card FFC cable to the system board.
4. Install the:
a. battery
b. base cover
15