Installing the display assembly
1. Connect the display cable to the connector and fix the adhesive tape.
2. Stick the aluminum foil on the thermal plate and display cable.
3. Connect the camera, touch-panel, and tune cable.
4. Align the display assembly with the screw holders on the computer.
5. Tighten the screws to secure the display assembly.
6. Install the:
a. WWAN card
b. WLAN card
7. Connect the battery cable to the connector on the system board.
8. Install the base cover.
9. Follow the procedure in After working inside your system.
Removing the system board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
c. SSD
d. WLAN card
24
To Next Page
Loading...
