Installing the WWAN card
1. Peel the aluminum foil until the folding line.
2. Insert the WWAN card into the slot on the computer.
3. Route the WWAN cables through the routing channel.
4. Connect the WWAN cables to the connectors on the WWAN Card.
5. Place the metal bracket and tighten the screw to secure it to the computer.
6. Stick the aluminum foil on the bracket and WWAN card.
7. Connect the battery cable to the connector on the system board.
8. Install the:
a. base cover
9. Follow the procedure in After working inside your system.
Removing the Solid State Drive (SSD)
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
3. Disconnect the battery cable from the connector on the system board [1].
20
To Next Page
Loading...
