Figure 25. Installing the right fan
Steps
1. Align and place the right fan onto the palm-rest assembly.
2. Replace the two (M1.6x3) screws to secure the right fan to the palm-rest assembly.
3. Connect the right-fan FPC cable to the connector (FANR) on the system board.
4. Adhere the mylar sticker on the system board.
Next steps
1. Install the base cover.
2. Install the Nano-SIM card tray.
3. Follow the procedure in after working inside your computer.
Removing the left fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Ensure that your computer is in Service Mode. For more information, see step 6 in Before working inside your
computer.
2. Remove the Nano-SIM card tray.
3. Remove the base cover.
About this task
The following image indicates the location of the left fan and provides a visual representation of the removal procedure.
Removing and installing Customer Replaceable Units (CRUs)
47
To Next Page
Loading...
