Dell Latitude 9450 2-in-1 - Palm-Rest and Keyboard Assembly; Removing the Palm-Rest and Keyboard Assembly

Next steps
1. Install the battery.
2. Install the WWAN card if applicable.
3. Install the base cover.
4. Follow the procedure in after working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information, see step 6 in before working inside your
computer.
2. Remove the nano-SIM card tray, if applicable.
3. Remove the base cover.
4. Remove the solid-state drive.
5. Remove the WWAN card, if applicable.
6. Remove the right fan.
7. Remove the left fan.
8. Remove the display assembly.
9. Remove the heat sink.
10. Remove the battery.
11. Remove the system board.
12. Remove the right-speaker.
13. Remove the power button.
84
Removing and installing Field Replaceable Units (FRUs)