Dell Latitude 9450 2-in-1 - Solid State Drive; Removing the Solid State Drive

Figure 27. Installing the left fan
Steps
1. Align and place the left fan onto the palm-rest assembly.
2. Replace the two (M1.6x3) screws to secure the left fan to the palm-rest assembly.
3. Connect the left-fan cable to the connector (FANL) on the system board.
4. Adhere the mylar sticker on the system board.
Next steps
1. Install the base cover.
2. Install the Nano-SIM card tray.
3. Follow the procedure in after working inside your computer.
Solid state drive
Removing the solid state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
NOTE:
Ensure that your computer is in Service Mode. For more information, see step 6 in before working inside your
computer.
2. Remove the Nano-SIM card tray.
3. Remove the base cover.
About this task
The following images indicate the location of the solid state drive and provide a visual representation of the removal procedure.
Removing and installing Customer Replaceable Units (CRUs)
49