Dell Latitude 9450 2-in-1 - Page 59

Figure 38. Removing the battery
Figure 39. Removing the battery
Steps
1. Remove the screw that secures the Darwin antenna cable (D2) bracket.
2. Lift the Darwin antenna cable (D2) bracket off the system board.
3. Loosen the captive screw that secures the WLAN bracket to the system board.
4. Lift the WLAN bracket off the system board.
5. Disconnect the black and white antenna cables that are connected to the WLAN module.
6. Unroute the black/grey D/G WWAN antenna cable from the routine guides along the sides of the battery.
Removing and installing Field Replaceable Units (FRUs)
59