Steps
1. Loosen the nine captive screws that secure the base cover to the system.
2. Using a plastic scribe, pry open the base cover starting from the recesses located in the U-shaped indents near the hinges at
the top edge of the base cover.
NOTE: Do not pull the base cover from the top side immediately after prying it from the recesses, as this will cause
damage to the base cover.
3. Pry open the left and right sides of the base cover.
4. Pry open the bottom side of the base cover.
5. Hold the left and right sides of the base cover and remove it from the system.
Installing the base cover
About this task
Removing and installing components 19
To Next Page
Loading...
