Dell Latitude 9520 2-in-1 - Installing the Display Assembly

CAUTION: This latch is fragile and requires care when flipping it up to unlock the camera cable.
3. Remove the three (M2.5x5) screws from the left hinge and fold back the left hinge.
NOTE:
Press the edges of the laptop near the hinges, and fold back the hinges in the upward direction away from the
laptop.
4. Remove the three (M2.5x5) screws from the right hinge and fold back the right hinge.
5. Open the system chassis to 45 degrees, and slide the system from the display assembly.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: The display assembly installation procedure is the same for both laptop and convertible chassis.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
54
Removing and installing components