Dell Latitude 9520 2-in-1 - Installing the Speaker

4. Enter service mode.
5. Remove the base cover.
About this task
The following images indicate the location of the speaker and provide a visual representation of the removal procedure.
Steps
1. Peel off the adhesive tape and disconnect the battery cable from the system board.
2. Disconnect the speaker cable, and unroute the speaker cable from the routing guide.
3. Remove the four (M1.6x1.8) screws that secure the speakers, and remove the speakers from the system.
Installing the speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
26
Removing and installing components