Dell Latitude 9520 2-in-1 - Installing the Power Button

Steps
1. Remove the three (M2.5x5) screws that secures the display hinge to the chassis and fold the hinge up.
2. Remove the three (M1.5x2.5) screws from the power-button bracket and remove the bracket from the system.
3. Peel off the power-button assembly from the palm rest and remove the power-button assembly from the system.
Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicate the location of the power button and provide a visual representation of the installation procedure.
36
Removing and installing components