Steps
1. Remove the single (M1.6x3.5) screw that secures the display-cable bracket and lift the display-cable bracket.
2. Using the pull tab, disconnect the display cable from the system board and peel back the camera cable from the system
board.
NOTE:
Users must disconnect the display cable from the system board by pulling the pull tab in a direct upward motion
to prevent damage to the connector's pins.
NOTE: The camera cable has a tiny latch that locks the cable and secures it to the system board. Users must lift this
latch to release the camera cable.
Removing and installing components 53
To Next Page
Loading...
