About this task
Steps
1. Align and place the smart card reader on the palmrest assembly.
2. Replace the two screws (M2x2) to secure the smart card reader to the palmrest assembly.
3. Connect the smart card reader cable to the connector on the I/O-daughter board and close the latch.
4. Connect the touchpad FPC to the connector on the system board and close the latch.
Next steps
1. Install the battery.
2. Install the speakers.
3. Install the base cover.
4. Install the SIM card tray.
5. Install the microSD card.
6. Follow the procedure in After working inside your computer.
46
Removing and installing components
To Next Page
Loading...
