Adding and Replacing Parts 101
Adding and Replacing Parts
Before You Begin
This chapter provides procedures for removing and installing the components in your computer.
Unless otherwise noted, each procedure assumes that the following conditions exist:
• You have performed the steps in "Turning Off Your Computer" on page 101 and "Before Working
Inside Your Computer" on page 102.
• You have read the safety information in the Dell™
Product Information Guide.
• A component can be replaced or—if purchased separately—installed by performing the removal
procedure in reverse order.
Recommended Tools
The procedures in this document may require the following tools:
• Small flat-blade screwdriver
• Small Phillips screwdriver
• Small plastic scribe
• Hex nut driver
• Flash BIOS update program CD
Turning Off Your Computer
NOTICE: To avoid losing data, save and close all open files and exit all open programs before you turn off your
computer.
1
Shut down the operating system:
a
Save and close all open files and exit all open programs.
b
In the Microsoft
®
Windows
®
XP operating system
, click
Start
→
Shut Down
→
Shut down
.
In Microsoft
®
Windows Vista™,
click the Windows Vista Start button, , in the lower-left
corner of the desktop, click the arrow in the lower-right corner of the Start menu as shown
below, and then click
Shut Down
.
To Next Page
Loading...
