Dell Latitude E5400 - Heat Sink

Back to Contents Page
Heat Sink
Dell™Latitude™E5400DiscreteServiceManual
Removing the Heat Sink
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery from the computer.
3. Remove the access panel from the computer.
4. Disconnect the fan cable from the system board.
5. Loosen the five captive screws that secure the heat sink to the computer.
6. Lift the heat sink and remove it from the computer.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.