Dell Latitude E5430 - Installing the Expresscard Reader Cage; Removing the Bluetooth Module; Installing the Bluetooth Module

Installing the ExpressCard Reader Cage
1. Align the ExpressCard reader cage to its original position in the computer and snap it into place.
2. Install the screws that secure the ExpressCard reader cage.
3. Install:
a) palmrest
b) right base panel
c) optical drive
d) keyboard
e) keyboard trim
f) access panel
g) battery
h) SD memory card
4. Follow the procedures in After Working Inside Your Computer.
Removing the Bluetooth Module
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a) SD memory card
b) battery
c) access panel
d) keyboard trim
e) keyboard
f) optical drive
g) right base panel
h) palmrest
3. Disconnect the bluetooth cable from the system board.
4. Remove the screw that secures the bluetooth module in place.
5. Remove the bluetooth module from the computer.
6. Disconnect the bluetooth cable from the bluetooth module.
Installing the Bluetooth Module
1. Connect the bluetooth cable to the bluetooth module.
2. Place the bluetooth module in its compartment in the computer.
34