Dell Latitude E5540 - Installing the Expresscard Cage; Removing the System Fan

Installing the ExpressCard Cage
1. Align the ExpressCard cage to its original position on the computer and snap it into place.
2. Install the screws that secure the ExpressCard cage to the system board.
3. Install:
a) palmrest
b) display hinge
c) keyboard
d) keyboard trim
e) base cover
f) battery
g) SD card
4. Follow the procedures in After Working Inside Your Computer.
Removing the System Fan
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a) SD card
b) battery
c) base cover
d) keyboard trim
e) keyboard
f) memory
g) optical drive
h) hard drive
i) hard-drive cage
j) display hinge
k) palmrest
3. Perform the following steps:
a) Disconnect the I/O board cable and system-fan cable [1] and [2].
b) Remove the screws that secure the system fan and lift to remove the system fan from the
computer.
27