Do you have a question about the Dell N1548 and is the answer not in the manual?
Model | N1548 |
---|---|
Category | Switch |
Enclosure Type | Rack-mountable - 1U |
Uplink Ports | 4 x 10 Gigabit SFP+ |
Switching Capacity | 176 Gbps |
Forwarding Rate | 131 Mpps |
MAC Address Table Size | 32, 000 entries |
Power Device | Internal power supply |
Voltage Required | AC 120/230 V (50/60 Hz) |
Jumbo Frame Support | 9 KB |
Routing Protocol | OSPF, RIP |
Remote Management Protocol | SNMP 1, SNMP 3, RMON |
Features | Flow control, DHCP support, BOOTP support, ARP support, VLAN support, IGMP snooping, Syslog support, port mirroring, DiffServ support, Weighted Round Robin (WRR) queuing, Access Control List (ACL) support, Quality of Service (QoS), Rapid Spanning Tree Protocol (RSTP) support, Multiple Spanning Tree Protocol (MSTP) support, IPv6 support |
Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3z |
Input Voltage | AC 100-240 V |
Dimensions (W x D x H) | 17.3 in x 16 in x 1.7 in |
Operating Temperature | 0°C to 45°C |
Operating Humidity | 10 - 90% (non-condensing) |
Storage Humidity | 5 to 95% (non-condensing) |
Information on accessing firmware, release notes, and additional assistance.
Requirements for administrators to perform firmware upgrades via CLI.
Guidance on downgrading firmware and configuration compatibility.
Lists part numbers for N1500 series switches with Hardware Revision 3.
Detailed steps for downloading the firmware image to the switch.
Steps to activate the new firmware image and reload the switch.
Instructions on connecting to the switch's serial console for management.
How to confirm the firmware version after the upgrade.
Procedure for upgrading firmware across a stack of N1500 series switches.
Steps to recover the switch using the boot menu and TFTP.
A practical example demonstrating the switch recovery process.