Dell N1548P - User Manual

Dell EMC Networking N1524/N1524P/N1548/N1548P
Upgrading Dell EMC
Networking
N1500 Series Switches to
6.5.2.9 Firmware
Date: September 2018
Information in this document is subject to change without notice.
Copyright © 2018 Dell Inc. All rights reserved.
This product is protected by U.S. and international copyright and intellectual property laws. Dell and the Dell logo are
trademarks of Dell Inc. in the United States and/or other jurisdictions. All other marks and names mentioned herein may be
trademarks of their respective companies.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo and PowerConnect are trademarks of Dell Inc; Intel and Pentium are registered
trademarks and Celeron is a trademark of Intel Corporation; Microsoft and Windows are registered trademarks of Microsoft
Corporation.
Other trademarks and trade names may be used in this document to refer to either the entity claiming the marks and names or
their products. Dell Inc disclaims any proprietary interest in trademarks and trade names other than its own. All rights reserved.
This document may not, in whole or in part, be copied, photocopied, reproduced, translated, or reduced to any electronic
medium or machine-readable form without the prior written consent of Dell. Dell reserves the right to make changes without
further notice to any products or specifications referred to herein to improve reliability, functionality or design.
Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under the copyright
laws.

Summary

Introduction to Dell EMC Networking Switch Firmware

Global Support for Dell EMC Networking Devices

Provides information on obtaining the latest firmware, release notes, and additional assistance from Dell.

Firmware Upgrade Process Overview

Details the prerequisites and general steps for performing a firmware upgrade on Dell EMC Networking switches.

Firmware Downgrade Process Overview

Explains the procedure for downgrading firmware and important considerations for Dell EMC Networking switches.

Accessing Serial Console for Dell EMC Networking Switches

Example Firmware Upgrade via Serial Console

Illustrates a step-by-step firmware upgrade example using a serial console connection.

Upgrading Dell EMC Networking N1500 Series Switch Stacks

Dell EMC Networking Switch Recovery Procedures

Example of Dell EMC Networking Switch Recovery

Provides a practical example of recovering a Dell EMC Networking switch from a boot menu.

Dell N1548P Specifications

General

Model	N1548P
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
PoE Power Budget	740 W
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Operating Temperature	0 °C to 45 °C
Device Type	Switch
Enclosure Type	Rack-mountable
Ports	48 x 10/100/1000
Uplink Ports	4 x 10G SFP+
Routing Protocol	OSPF, RIP, VRRP
Remote Management Protocol	SNMP 1, Telnet, SSH, HTTP, HTTPS
Features	Layer 3 switching, IGMP snooping, Link Aggregation Control Protocol (LACP), Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.1p, IEEE 802.3af, IEEE 802.3x, IEEE 802.3ad
Dimensions	4.32 cm
Storage Temperature	70 °C
Relative Humidity	10 to 90% (non-condensing)
Jumbo Frame Support	9216 bytes