EasyManua.ls Logo

Dell N1524 User Manual

Dell N1524
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Dell EMC Networking N1524/N1524P/N1548/N1548P
Upgrading Dell EMC
Networking
N1500 Series Switches to
6.5.2.9 Firmware
Date: September 2018
Information in this document is subject to change without notice.
Copyright © 2018 Dell Inc. All rights reserved.
This product is protected by U.S. and international copyright and intellectual property laws. Dell and the Dell logo are
trademarks of Dell Inc. in the United States and/or other jurisdictions. All other marks and names mentioned herein may be
trademarks of their respective companies.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo and PowerConnect are trademarks of Dell Inc; Intel and Pentium are registered
trademarks and Celeron is a trademark of Intel Corporation; Microsoft and Windows are registered trademarks of Microsoft
Corporation.
Other trademarks and trade names may be used in this document to refer to either the entity claiming the marks and names or
their products. Dell Inc disclaims any proprietary interest in trademarks and trade names other than its own. All rights reserved.
This document may not, in whole or in part, be copied, photocopied, reproduced, translated, or reduced to any electronic
medium or machine-readable form without the prior written consent of Dell. Dell reserves the right to make changes without
further notice to any products or specifications referred to herein to improve reliability, functionality or design.
Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under the copyright
laws.
Question and Answer IconNeed help?

Do you have a question about the Dell N1524 and is the answer not in the manual?

Dell N1524 Specifications

General IconGeneral
ModelN1524
ManageableYes
Ports24 x 10/100/1000BASE-T
Uplink Ports2 x 10GbE SFP+
Switching Capacity128 Gbps
Forwarding Rate95.2 Mpps
MAC Address Table Size16K entries
PoENo
Power SupplyInternal
Product TypeSwitch
Operating Temperature32°F to 113°F (0°C to 45°C)
Storage Temperature-40°F to 158°F (-40°C to 70°C)
Humidity10% to 90% (non-condensing)
Jumbo Frame SupportUp to 9, 000 bytes
Weight3.9 kg

Summary

Dell EMC Networking N1500 Series Firmware Upgrade

Introduction and Overview

Provides an introduction, global support, and an overview of firmware upgrade and downgrade processes.

Upgrade Prerequisites and Considerations

Details CLI access requirements, hardware revision considerations, and important notes for firmware upgrades.

Firmware Upgrade Procedure

Download, Activate, and Reload Switch

Steps to download the 6.5.2.9 firmware image, activate it, and reload the switch.

Update Boot-Code

Procedure to update the boot-code for the new firmware.

HiveAgent Pre-Upgrade Tasks

Commands required for HiveAgent application upgrade before firmware upgrade.

Firmware Verification and Readiness

Verifying the 6.5.2.9 firmware update and confirming switch readiness for operation.

Upgrading a Switch Stack

Stack Upgrade Process and Verification

Notes on the 'copy' command for stacks, distributing code, and verifying the update on members.

Updating Stack Boot-Code

Commands to update the boot-code on the stack master CLI for all members.

Switch Recovery Procedure

Recovery Connection and TFTP Download

Steps for recovery connection, boot menu selection, and TFTP firmware download.

Verifying Recovery Firmware

Verifying the firmware version is loaded correctly after the recovery process.

Related product manuals