Need help?Do you have a question about the Dell Networking N3048 and is the answer not in the manual?
General| Model | Dell Networking N3048 |
|---|---|
| Ports | 48 x 10/100/1000BASE-T |
| Switching Capacity | 176 Gbps |
| Forwarding Rate | 131 Mpps |
| MAC Address Table Size | 32, 000 entries |
| Jumbo Frame Support | Yes |
| Jumbo Frame Size | 9216 Bytes |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Storage Temperature | -40°C to 65°C (-40°F to 149°F) |
| Rack Units | 1U |
| Manageable | Yes |
| Input Voltage | 100-240 VAC |
| Humidity | 95% non-condensing |
| Layer | Layer 2 and Layer 3 |
| Dimensions | 17.3 x 17.4 x 1.7 inches (440 x 442 x 44 mm) |
Describes expansion modules for blade switches installed in the Dell M1000e chassis.
Details expansion modules for the Dell Networking M8024-k blade switch, including 10G optics support.
Lists expansion modules compatible with the Dell Networking M8024 blade switch.
Details expansion modules for the Dell Networking M6220 blade switch, including stacking and CX4 options.
Explains expansion modules for the Dell Networking MXL blade switch, compatible with N40xx/81xx series.
States the Dell Networking M6348 has no expansion slots and does not support modules.
Details supported modules for Dell Networking N3000 series switches, including 10BBASE-T and SFP+.
Lists expansion modules for Dell Networking N4000 series, including 10GBASE-T, SFP+, and 40G QSFP.
Covers expansion modules for Dell Networking 8100 series, compatible with N40xx and MXL switches.
Details expansion modules for Dell Networking 7000 series, featuring two bays and CX4 stacking modules.
Explains expansion modules for Dell Networking 62xx series, compatible with M6220 modular switches.
To Next Page