Need help?Do you have a question about the Dell Networking N3048P and is the answer not in the manual?
General| Switching Capacity | 176 Gbps |
|---|---|
| Forwarding Rate | 131 Mpps |
| Rack Units | 1U |
| Enclosure Type | Rack-mountable |
| Subtype | Gigabit Ethernet |
| Power Device | Internal power supply |
| Installed Qty | 1 |
| Voltage Required | AC 120/230 V (50/60 Hz) |
| Power Supply | AC 120/230 V (50/60 Hz) |
| Ports | 48 x 10/100/1000Base-T |
| Uplink Ports | 4 x 10G SFP+ |
| Device Type | Switch - stackable |
| Jumbo Frame Support | 9KB |
| Routing Protocol | OSPF, RIP, VRRP, PIM-SM, PIM-SSM |
| Remote Management Protocol | SNMP 1, SNMP 3, Telnet, SSH-2, CLI |
| Features | Flow control, DHCP support, VLAN support, IGMP snooping, Syslog support, DoS attack prevention, port mirroring, DiffServ support, Weighted Round Robin (WRR) queuing, Broadcast Storm Control, IPv6 support, Multicast Storm Control, Unicast Storm Control, Rapid Spanning Tree Protocol (RSTP) support, Multiple Spanning Tree Protocol (MSTP) support, DHCP snooping, Quality of Service (QoS), MLD snooping, LLDP support, Port Security |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3x, IEEE 802.3ad (LACP), IEEE 802.3at |
| Operating Temperature | 32 °F to 113 °F (0 °C to 45 °C) |
| Operating Humidity | 10 to 90% (non-condensing) |
| MAC Address Table Size | 32000 entries |
| Weight | 7.93 kg |
Lists five groups of Dell Networking switches that can interchange expansion modules.
Details possible configurations for expansion module bays, including single and dual bay setups.
Table comparing SFP+ expansion module ports and fixed ports across various Dell switch models.
Overview of the M1000e chassis, its switch slots, and the role of expansion modules.
Details expansion modules for the M8024-k blade switch, noting 10G optics limitation on expansion ports.
Lists available expansion modules for the M8024 blade switch and their compatibility with bays.
Covers expansion modules for the M6220 blade switch, including specific bay restrictions and module roles.
Outlines expansion modules for the MXL blade switch, including QSFP and 10GBase-T options.
Notes that the M6348 switch lacks expansion slots and does not support expansion modules.
Details 10BBASE-T and SFP+ modules for the N3000 series rack switches.
Lists 10GBASE-T, SFP+, and 40G QSFP modules for the N4000 series rack switches.
Describes 10G SFP+, 40G QSFP, and 10GbaseT modules for the 8100 series rack switches.
Covers SFP+, 10GBase-T, and CX4 stacking modules for the 7000 series rack switches.
Details SFP+, 10GBase-T, CX4, and XFP modules for the 62xx series rack switches.
To Next Page