Do you have a question about the Dell Networking N3048P and is the answer not in the manual?
Switching Capacity | 176 Gbps |
---|---|
Forwarding Rate | 131 Mpps |
Rack Units | 1U |
Enclosure Type | Rack-mountable |
Subtype | Gigabit Ethernet |
Power Device | Internal power supply |
Installed Qty | 1 |
Voltage Required | AC 120/230 V (50/60 Hz) |
Power Supply | AC 120/230 V (50/60 Hz) |
Ports | 48 x 10/100/1000Base-T |
Uplink Ports | 4 x 10G SFP+ |
Device Type | Switch - stackable |
Jumbo Frame Support | 9KB |
Routing Protocol | OSPF, RIP, VRRP, PIM-SM, PIM-SSM |
Remote Management Protocol | SNMP 1, SNMP 3, Telnet, SSH-2, CLI |
Features | Flow control, DHCP support, VLAN support, IGMP snooping, Syslog support, DoS attack prevention, port mirroring, DiffServ support, Weighted Round Robin (WRR) queuing, Broadcast Storm Control, IPv6 support, Multicast Storm Control, Unicast Storm Control, Rapid Spanning Tree Protocol (RSTP) support, Multiple Spanning Tree Protocol (MSTP) support, DHCP snooping, Quality of Service (QoS), MLD snooping, LLDP support, Port Security |
Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3x, IEEE 802.3ad (LACP), IEEE 802.3at |
Operating Temperature | 32 °F to 113 °F (0 °C to 45 °C) |
Operating Humidity | 10 to 90% (non-condensing) |
MAC Address Table Size | 32000 entries |
Weight | 7.93 kg |