Need help?Do you have a question about the Dell Networking S4048 and is the answer not in the manual?
General| Uplink Ports | 6 x 40GbE QSFP+ |
|---|---|
| Rack Units | 1 RU |
| Power Supply | Dual, hot-swappable |
| Airflow | Front-to-back or back-to-front |
| Form Factor | Rack-mountable |
| Jumbo Frame Support | Yes, up to 9216 bytes |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| AC Input Voltage | 100-240 VAC |
| AC Input Frequency | 50/60 Hz |
| Switching Capacity | 1.44 Tbps |
| Latency | Less than 800 ns |
| Product Type | Switch |
| Humidity | 10% to 90% (non-condensing) |
| Dimensions | 43.9 x 4.3 x 44.9 cm (17.3 x 1.7 x 17.7 in) |
| Management | CLI, SNMP, Web UI |
| Layer Support | Layer 2 and Layer 3 |
Instructions for mounting the system in a rack and ensuring proper grounding.
Details on fan configurations, airflow requirements, and power connection.
Procedures for unpacking the system, checking components, and initial setup.
Instructions for installing the system into a rack or cabinet.
Guidance on installing the Dell ReadyRails system for rack mounting.
Guidance on installing and replacing SFP+ and QSFP+ optical modules.
Steps and considerations for powering up the system after installation.
Procedures for installing and replacing AC power supply units.
Steps for installing DC power supply units and making connections.
Instructions for accessing the system console via RS-232 and Micro USB ports.
To Next Page