Dell Networking S4048 - S4048-ON Installation; 1 U Front-Rack Installation

Figure 9. Four-post threaded conguration
2 For each rail, attach the front and rear anges to the post anges with two user-supplied screws at each end, item 2.
S4048-ON installation
You can mount the system in the 1U front-rack or 1U ush and center two-post congurations. The following is an example of a front-rack
conguration:
For the 1U ush and center two-post congurations, slide the system into the rails in the same manner as the four-post congurations.
1U front-rack installation
You must congure the rails that are attached to the system.
1 Attach the inner chassis members switch rails to the S4048–ON system.
Item 3 shows the detail for the front stando with the locking tab.
S4048–ON installation
21