Need help?Do you have a question about the Dell N1108T-ON and is the answer not in the manual?
General| Device Type | Switch |
|---|---|
| Ports | 8 x 10/100/1000BASE-T |
| Power over Ethernet (PoE) | No |
| Manageable | Yes |
| Layer | Layer 2 |
| Jumbo Frame Support | Yes |
| Jumbo Frame Size | 9216 bytes |
| Form Factor | Rack-mountable |
| Product Type | Network Switch |
| MAC Address Table Size | 16K entries |
| Power Supply | Internal power supply |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Storage Temperature | -40 to 70 °C |
| Humidity | 10% to 90% (non-condensing) |
| Warranty | Lifetime |
| Management | Web-based, CLI |
Defines NOTE, CAUTION, and WARNING terms used in the guide.
Details safety measures for handling lithium batteries to prevent explosions or leakage.
Provides information about device characteristics and modular hardware configurations for the N1100-ON Series switch.
Details power consumption for N1100-ON Series PoE switches, including voltage and power ratings.
Instructions for rack mounting the N1108T-ON/N1108P-ON switch, including safety warnings.
Step-by-step guide for installing the switch into a rack, with specific mounting cautions.
Guide for rack mounting N1124T/N1124P/N1148T/N1148P-ON switches with safety warnings.
Steps for attaching rack-mounting brackets and securing the switch into a 19-inch rack.
Provides an overview of the steps for initial configuration after unpacking and mounting the switch.
Lists the necessary equipment for connecting to the switch console port, including computer and cable.
Step-by-step guide for connecting a terminal to the switch console port and configuring emulation software.
Details the process for connecting the switch to an AC power source, including cable requirements.
Explains the POST process that the switch undergoes upon power-on and its significance.
Describes how to invoke the Boot menu for configuration tasks after POST completion.
Lists the prerequisites and assumptions for performing the initial switch configuration.
Specifies essential network information required from the administrator before setup.
Explains how to enable remote management using switch ports and configuring network information for VLAN 1.
Compares using the Dell Easy Setup Wizard and the CLI for initial switch configuration.
Details the configuration steps performed by the Dell Easy Setup Wizard, such as user accounts and IP settings.
Lists example values used in a Dell Easy Setup Wizard session, including SNMP string, IP addresses, and user credentials.
Summarizes the switch configuration after completing the setup wizard, including SNMP, user accounts, and network settings.
Presents the End User License Agreement for SupportAssist, detailing data collection and usage.
Explains the EULA for HiveManager NG and how to disable the feature, including the command to use.
Introduces the welcome message of the Dell Easy Setup Wizard and options to proceed or skip.
Guides on setting up the SNMP community string, specifying 'public' and an IP address.
Instructions on entering the management system IP address for managing the switch.
Details on setting up the initial privileged user account with a username and password.
Steps for setting up the IP address and subnet mask for the VLAN 1 routing interface.
Guides on setting the default gateway IP address for network reachability.
Instructions on saving the collected configuration settings to the startup configuration file.
Outlines post-configuration steps, including connecting to the network and accessing management interfaces.
Lists basic switching features supported, such as VLANs and spanning tree protocol.
Directs users to the User Configuration Guide or CLI Reference Guide for more information.
Provides exporter and importer information for compliance with Mexican standards (NOM).
Details supply voltage and maximum steady state current consumption for the switches as per NOM requirements.
To Next Page
