Getting Started Guide 7
N1108T-ON/N1108P-ON Installation
Rack Mounting an N1108T-ON/N1108P-ON Switch
WARNING: Read the safety information in the
Safety and Regulatory Information
as well as the safety information for other switches that connect to or support the
switch.
The AC power connector is on the rear panel of the switch.
Installing in a Rack
WARNING: Do not use rack mounting kits to suspend the switch from under a
table or desk, or attach it to a wall.
CAUTION: Disconnect all cables from the switch before continuing. Remove all
self-adhesive pads from the underside of the switch, if they have been attached.
CAUTION: When mounting multiple switches into a rack, mount the switches
from the bottom up.
1
Secure the N1108T-ON/N1108P-ON switch in either the Dell Rack Mount
Kit as shown in Figure 1-1 or the Dell Tandem Tray Kit as shown in
Figure 1-2.
Figure 1-1. Dell Rack Mount Kit
To Next Page
Loading...
