Upgrade Dell EMC Networking N1500 Series Switches  
 
 
 
Page 6 
 
Programming controller register 
ddr_init2: MemC initialization complete 
Validate Shmoo parameters stored in flash ..... OK 
Press Ctrl-C to run Shmoo ..... skipped 
Restoring Shmoo parameters from flash ..... done 
Running simple memory test ..... OK 
DeepSleep wakeup: ddr init bypassed 3 
DDR Interface Ready 
CPLD: addr=0x21, rev=10 
Board: L2 48 Port Copper POE+ Switch, X01 
DRAM:  1 GiB 
NAND:   Micron MT29F1G08ABADA, 128 KiB blocks, 2 KiB pages, 16B OOB, 8-bit 
NAND:   chipsize 128 MiB 
In:    serial 
Out:   serial 
Err:   serial 
arm_clk=1000MHz, axi_clk=400MHz, apb_clk=100MHz, arm_periph_clk=500MHz 
Unlocking L2 Cache ...Done 
l2cc_invalidate - Done, i = 981, invway = 0 
Net:   Registering eth 
Broadcom BCM IPROC Ethernet driver 0.1 
Using GMAC0 (0x18022000) 
et0: ethHw_chipAttach: Chip ID: 0xdb56; phyaddr: 0x1 
ethHw_miiphy_write (addr&f):phyaddr (addr&1f00):bank 
ethHw_miiphy_write phyaddr(0x1) bank(0x0) reg(0x0) data(0x2100) 
bcmiproc_eth-0 
========== relocate address: 0xdff7c000, offset 0xc1f7c000 ========== 
boot in 3 s 
Creating 1 MTD partitions on "nand0": 
0x000000200000-0x000007000000 : "mtd=4" 
UBI: attaching mtd1 to ubi0 
UBI: physical eraseblock size:   131072 bytes (128 KiB) 
UBI: logical eraseblock size:    126976 bytes 
UBI: smallest flash I/O unit:    2048 
UBI: VID header offset:          2048 (aligned 2048) 
UBI: data offset:                4096 
1 ecc_errors after reading 2320800:2320a00 
UBI: attached mtd1 to ubi0 
UBI: MTD device name:            "mtd=4" 
UBI: MTD device size:            110 MiB 
UBI: number of good PEBs:        880 
UBI: number of bad PEBs:         0 
UBI: max. allowed volumes:       128 
UBI: wear-leveling threshold:    4096 
UBI: number of internal volumes: 1 
UBI: number of user volumes:     1 
UBI: available PEBs:             8 
UBI: total number of reserved PEBs: 872 
UBI: number of PEBs reserved for bad PEB handling: 8 
UBI: max/mean erase counter: 37/16 
UBIFS: recovery needed 
UBIFS: recovery deferred 
UBIFS: mounted UBI device 0, volume 0, name "fs" 
UBIFS: mounted read-only 
UBIFS: file system size:   107802624 bytes (105276 KiB, 102 MiB, 849 LEBs) 
UBIFS: journal size:       5459968 bytes (5332 KiB, 5 MiB, 43 LEBs)