Dell Networking S4810

11 SCG1000 | Dell Networking S4810 and Force10 S4810 Configuration Guide for EqualLogic SANs
3.5 Configure DCB policies
FTOS(conf)#dcb-map profile-name
FTOS(conf-dcbmap-profile-name*)#priority-group 0 bandwidth 50 pfc off
FTOS(conf-dcbmap-profile-name*)#priority-group 1 bandwidth 50 pfc on
Note: The sum of the bandwidth-percentages must be equal to 100.
FTOS(conf-dcbmap-profile-name*)#priority-pgid 0 0 0 0 1 0 0 0
FTOS(conf-dcb-profile-name*)#exit
3.6 Apply policies to switch ports
FTOS(conf)#interface range ten 0/0 – 47
FTOS(conf-if-range-te-0/0-47)# dcb-map profile-name
FTOS(conf-if-range-te-0/0-47)#exit
FTOS(conf)#interface range fortyGigE 0/48 , fortyGigE 0/52
FTOS(conf-if-range-fo-0/48,fo-0/52)# dcb-map profile-name
FTOS(conf-if-range-fo-0/48,fo-0/52)#exit
FTOS(conf)#exit
Note: The sum of the bandwidth-percentages must be equal to 100.
3.7 Save configuration
FTOS#copy running-config startup-config
3.8 Configure additional switches
Repeat the commands from section 3 to configure DCB on additional switches.