Dell OptiPlex 3030 All-in-One - 3 Removing and Installing Components; Stand Removal and Installation; Back Cover Removal and Installation

3
Removing and Installing Components
This section provides detailed information on how to remove or install the components from your
computer.
Removing the Stand
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the stand cover.
3. Remove the screws that secure the stand to the computer and remove the stand from the computer.
Installing the Stand
1. Align the stand on the computer, and tighten the screws to secure the stand to the computer.
2. Place and press the panel on the computer until it clicks into place.
3. Install stand cover.
4. Follow the procedures in After Working Inside Your Computer.
Removing the Back Cover
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. stand cover
b. stand
11