Dell OptiPlex 3030 All-in-One - Memory Module Removal and Installation

3. Disconnect the cables from the convertor board. Remove the screws and lift the convertor board
from the computer.
Installing the Convertor Board
1. Tighten the screws to secure the convertor board to the computer. Connect the cables to the
convertor board.
2. Install:
a. back cover
b. stand
c. stand cover
3. Follow the procedures in After Working Inside Your Computer.
Removing the Memory
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. stand cover
b. stand
c. back cover
16