Installing the Power-Switch Board
1. Insert the power-switch board into its slot on the computer and fix the tape to secure it. Connect the
power-switch cable to the power-switch board.
2. Install:
a. back cover
b. stand
c. stand cover
3. Follow the procedures in After Working Inside Your Computer.
Removing the System Board
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. stand cover
b. stand
c. back cover
d. memory
e. VESA bracket
f. system-board shield
g. heatsink
h. WLAN card
25
To Next Page
Loading...
