3. Perform the following steps as shown in the illustration:
a. Remove the screws that secure the system-board shield to the computer [1].
b. Lift the system-board shield from the computer [2].
c. Remove the system-board shield from the computer [3].
Installing the System-Board Shield
1. Align the system-board shield on the system board. Tighten the screws to secure it to the computer.
2. Install:
a. back cover
b. stand
c. stand cover
3. Follow the procedures in After Working Inside Your Computer.
Removing the Heatsink
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. stand cover
b. stand
c. back cover
d. system-board shield
18
To Next Page
Loading...
