Installing the intrusion switch
1 Insert the intrusion switch into the slot on the chassis.
2 Connect the intrusion switch cable to the system board.
3 Install the:
a cover
4 Follow the procedure in After working inside your computer.
Storage
Depending on the conguration you choose, you will have either one 3.5–inch hard drive assembly or two 2.5–inch hard drive assembly.
Removing 2.5-inch drive assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a cover
3 To remove the 2.5-inch drive assembly:
a Push the release tabs and disconnect the 2.5-inch drive power cable [1][2].
b Disconnect the 2.5-inch drive assembly cables from the drives [3] [4].
Removing and installing components
15
To Next Page
Loading...
