About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the installation
procedure.
Steps
1. Slide the intrusion switch into the slot on the chassis.
2. Insert the connector from intrusion switch cable into the connector on the system board until it clicks into place.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Front bezel
Removing the front bezel
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the front bezel and provide a visual representation of the removal procedure.
16
Removing and installing components
To Next Page
Loading...
