Table 16. Integrated Devices (continued)
Options Description
● Front Port 3 (Top Left)
● Front Port 4 (Top Right)
Rear USB Configuration
This section allows the user to manually enable the 4 USB
ports on the back (All USB ports are enabled by default.). The
options are:
● Rear Port 1 (Top Left)
● Rear Port 2 (Left Middle)
● Rear Port 3 (Bottom Left)
● Rear Port 4 (Bottom Right)
● Rear Port 4 (Middle Right)
● Rear Port 4 (Top Right)
Dust Filter Maintenance
This field enabled or disabled BIOS messages for maintaining
the optional dust filter. BIOS will generate a pre-boot reminder
to clean or replace the dust filter based on the following time
intervals:
● Disabled (selected by default)
● 15 days
● 30 days
● 60 days
● 90 days
● 120 days
● 150 days
● 180 days
Storage
This section provides storage details and settings.
Table 17. Storage
Options Description
SATA Operation
SATA Operation
This section allows the user to select the operating mode
of the integrated SATA hard drive controller. The following
options are available:
● Disabled - SATA controllers are disabled.
● AHCI - SATA is configured in AHCI mode.
● RAID On - SATA is setup to support RAID (Intel Rapid
Storage Technology). (Selected by default)
Storage Interface
Port Enablement
This section allows the user to enable or disable the onboard
drives on the computer. The following options is available (ON
by default).
● SATA-0
● SATA-1
● SATA-3
● M.2 PCIe SSD-0
● M.2 PCIe SSD-1
SMART Reporting
74 System setup
To Next Page
Loading...
