Steps
1. Ensure that the securing clips are in an open position.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Insert the memory module into the memory-module connector until the memory module snaps into position and the securing
clip locks in place.
NOTE:
The securing clips return to the locked position. If you do not hear the click, remove the memory module and
reinstall it.
NOTE: Repeat step 1 to step 3 when installing more than one memory module in your computer.
Next steps
1. Install the 2.5/3.5-inch hard-drive caddy.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Processor
Removing the processor
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the 2.5/3.5-inch hard-drive caddy.
3. Remove the side cover.
4. Remove the fan and heat-sink assembly.
NOTE:
The processor may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
Removing and installing components 45
To Next Page
Loading...
