2.5-inch hard drive assembly
Removing the 2.5–inch hard drive assembly
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. Side cover
b. Front bezel
3. Open the front panel door.
4. To remove the hard drive assembly:
a. Disconnect the hard drive data and power cables from the connectors on the 2.5-inch hard drive [1].
b. Press the blue tabs of the assembly on both sides [2] and pull the hard drive assembly out of the system [3].
Installing the 2.5-inch drive assembly
1. To install the hard drive:
a. Insert the hard drive assembly into the slot on the system until it clicks into place [1] [2].
b. Connect the hard drive data and power cables to the connectors on the 2.5-inch hard drive [3].
22
Disassembly and reassembly
To Next Page
Loading...
