Dell OptiPlex 7060 Tower - Intrusion Switch Replacement

2. Close the front panel door.
3. Install the:
a. Front bezel
b. Side cover
4. Follow the procedure in After working inside your computer.
Intrusion switch
Removing intrusion switch
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. Side cover
b. Front bezel
3. Open the front panel door.
4. To remove the intrusion switch:
a. Disconnect the intrusion switch cable from the connector on the system board [1].
b. Unroute the intrusion switch cable from the fan grommets [2].
c. Slide the intrusion switch and push it to remove from the computer [3].
40
Disassembly and reassembly