Dell OptiPlex 7420 - Mil-SPEC, for Computers with High Performance Processors

Mil-SPEC, for computers with High Performance
processors
The OptiPlex All-in-One 7420 meets military specifications for the following MIL-STD 810H tests verified by SGS laboratories:
Table 51. Military specifications 
Test category Test method Test parameters Result
Altitude (Storage/Air
transport)
MIL-STD-810H, Method
500.6, Procedure I
● Test pressure: Equivalent
to cabin altitude of 15,000
feet
● Test temperature: 21°C
● Altitude change rate: <10
m/s
● Duration: 1 hour
Pass
Altitude (Operational/Air
carriage)
MIL-STD-810H, Method
500.6, Procedure II
● Test temperature: 21°C
● Altitude change rate: <10
m/s
● Duration: 1 hour
Pass
High temperature (Storage
and transition)
MIL-STD-810H, Method
501.7, Procedure I
● Test temperature: 33°C
to 71°C (non-operational/
storage), Table 501.7—III
High temperature cycles
● Duration: 7 x 24 hours per
cycle
● Climate category A1: Hot
dry
Pass
High temperature (Operation) MIL-STD-810H, Method
501.7, Procedure II
● Test temperature: 32°C
to 49°C (Ambient air),
Table 501.7—III High
temperature cycles
● Duration: 5 x 24 hours per
cycle
● Climate category A1: Hot
dry
Pass
Low temperature (Storage) MIL-STD-810H, Method
502.7, Procedure I
● Test temperature: -51°C
● Duration: 24 hours
Pass
Low temperature (Operation) MIL-STD-810H, Method
502.7, Procedure II
● Test temperature: -29°C
● Duration: 24 hours
Pass
Humidity MIL-STD-810H, Method
507.6, Procedure I
● Induced cycles (Storage
and Transit
● Duration: Table 507.6-II
(Hot-humid cycle B3)
● Material category: Non-
Hazardous items normal
test duration
● Duration: 12 hours, Air
velocity = 1.5 m/s
Pass
Sand and dust (Blowing dust) MIL-STD-810H, Method
510.7, Procedure I
● (300 feet/minute) to 8.90
m/s (1750 feet/minute)
● Temperature: 60°C
● Relative humidity: 30%
Pass
50 Engineering specifications