Dell OptiPlex 7490 All-In-One - Removing the M.2 2280 solid-state drive;Intel Optane memory module

Steps
1. Align the notch on the solid-state drive with the tab on the M.2 card slot.
2. Slide the solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x2.5) to secure the solid-state drive to the system board.
Next steps
1. Install the system-board shield.
2. Install the back cover.
3. Install the cable cover (optional).
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Removing the M.2 2280 solid-state drive/Intel Optane memory
module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the cable cover (optional).
4. Remove the back cover.
5. Remove the system-board shield.
About this task
The following image indicates the location of the M.2 2280 solid-state drive/Intel Optane memory module and provides a visual
representation of the removal procedure.
Removing and installing components
33