Steps
With the positive-side facing up, insert the coin-cell battery into the battery holder on the system board and gently press the
battery until it snaps into place.
Next steps
1. Install the system-board shield.
2. Install the back cover.
3. Install the cable cover (optional).
4. Install the stand.
5. Follow the procedure in After working inside your computer.
Wireless card
Removing the wireless card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the cable cover (optional).
4. Remove the back cover.
5. Remove the system-board shield.
About this task
The following image indicates the location of the wireless card and provides a visual representation of the removal procedure.
Removing and installing components
39
To Next Page
Loading...
