Steps
1. Align the screw holes on the side I/O-board with the screw holes on the display-assembly base.
2. Replace the two screws (M2.5x3.5) to secure the side I/O-board to the display-assembly base.
3. Route the SIO-signal cable, SIO-power cable, and audio-board cable through the routing guides on the display-assembly
base.
4. Connect the SIO-signal cable, SIO-power cable, and audio-board cable to the connectors on the system board.
5. Align the screw holes on the side I/O-board shield with the screw holes on the display-assembly base.
6. Replace the two screws (M3x5) to secure the side I/O-board shield to the display-assembly base.
Next steps
1. Install the speakers.
2. Install the rear-I/O bracket.
3. Install the bottom cover.
4. Install the system-board shield.
5. Install the hard drive.
6. Install the back cover.
7. Install the cable cover (optional).
8. Install the stand.
9. Follow the procedure in After working inside your computer.
Audio board
Removing the audio board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the cable cover (optional).
4. Remove the back cover.
5. Remove the system-board shield.
6. Remove the wireless card.
7. Remove the bottom cover.
8. Remove the rear-I/O bracket.
9. Remove the speakers.
10. Remove the side-I/O board.
About this task
The following image indicates the location of the audio board and provides a visual representation of the installation procedure.
74
Removing and installing components
To Next Page
Loading...
Need help?
General
