Steps
1. Align and place the PSU in the slot on the display-assembly base.
2. Replace the screw (M3x5) to secure the PSU to the display-assembly base.
3. Connect the power-supply cable to the connector on the system board.
4. Route the power-supply cable through the routing guides on the rear-I/O bracket and PSU fan.
5. Align the screw hole on the power-supply socket with the screw hole on the rear-I/O bracket, and place it in the slot on the
rear-I/O bracket.
6. Replace the screw (M3x5) to secure the power-supply socket to the rear-I/O bracket.
Next steps
1. Install the bottom cover.
2. Install the system-board shield.
3. Install the back cover.
4. Install the cable cover (optional).
5. Install the stand.
6. Follow the procedure in After working inside your computer.
Power-supply fan
Removing the PSU fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the cable cover (optional).
4. Remove the back cover.
5. Remove the system-board shield.
6. Remove the bottom cover.
About this task
The following image indicates the location of the PSU fan and provides a visual representation of the removal procedure.
50
Removing and installing components
To Next Page
Loading...
