Dell OptiPlex 9020 AIO - Removing the Camera

f) power supply unit
g) power-supply fan
h) converter board
i) power and on-screen display (OSD) buttons board
j) intrusion switch
k) hard drive
l) optical drive
m) WLAN card
n) input/output (I/O) board shield
o) system-board shield
p) VESA mount bracket
q) back cover
r) VESA stand
7. Follow the procedures in After Working Inside Your Computer .
Removing the Camera
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a) VESA stand
b) back cover
c) VESA mount bracket
d) system-board shield
e) input/output (I/O) board shield
f) WLAN card
g) optical drive
h) hard drive
i) intrusion switch
j) power and on-screen display (OSD) buttons board
k) converter board
l) processor fan
m) power supply unit
n) heat-sink assembly
o) power-supply fan
p) system board
q) display panel
3. Lift the latch and disconnect the camera cable. Remove the screws that secure the camera to the chassis.
40