4. Connect the power cable (DB-PWR) to the audio board and close the latch.
5. Connect the high-speed cable (DB-PWR) to the audio board and close the latch.
6. Place the audio-board shield on the display-assembly base.
7. Align the screw holes on the audio-board shield with the screw holes on the display-assembly base.
8. Replace the three screws (M3x5) that secure the audio-board shield to the display-assembly base.
Next steps
1. Install the I/O bracket.
2. Install the bottom cover.
3. Install the I/O cover.
4. Install the system-board shield.
5. Install the back cover.
6. Install the stand.
7. Follow the procedure in After working inside your computer.
Display-assembly base
Removing the display-assembly base
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
4. Remove the graphics card.
5. Remove the system-board shield.
6. Remove the wireless card.
7. Remove the I/O cover.
8. Remove the bottom cover.
9. Remove the retractable-camera assembly.
10. Remove the fan.
11. Remove the power-supply unit.
12. Remove the power-supply fan.
13. Remove the I/O bracket.
14. Remove the speakers.
15. Remove the heat sink.
16. Remove the system board.
NOTE:
The system board can be removed with the memory, solid-state drive(s), coin-cell battery, and processor
attached.
17. Remove the audio board.
18. Remove the power-button and I/O board.
About this task
NOTE:
The display-assembly base includes the following components:
● antenna modules
● display panel
● middle frame
To replace any of these components, replace the entire display-assembly base.
The following image(s) indicate the location of the display-assembly base and provides a visual representation of the removal
procedure.
102
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
