● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx #5 (T5) screwdriver
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 24. Screw list
Component Screw type Quantity Screw image
M.2 2230/M.2 2280 Solid-state
drive
M2x3.5 1
Hard-drive and optical-drive
supporting bracket
#6-32 1
Optical-drive supporting bracket M2x2 1
2.5-inch Hard-drive
M3x3.5 4
3.5-inch Hard-drive
#6-32 4
Serial/VGA module M2x5
2
DP/HDMI/Type-C module M3x3 2
SD-card reader M3x5 1
WLAN card M2x3 1
Processor-fan and heat-sink
assembly
Captive 4
Voltage regulator heat-sink Captive 4
Power-supply unit #6-32 3
Working inside your computer 33
To Next Page
Loading...
