4. Remove the base cover.
5. Remove the 3-cell battery or 4-cell battery.
6. Remove the WLAN card.
7. Remove the WWAN card (optional).
8. Remove the M.2 2280 SSD or M.2 2230 SSD.
9. Remove the fan.
10. Remove the system board.
NOTE: The system board can be removed with the heat sink attached in order to simplify the procedure and preserve
the thermal bond between the system board and heat sink.
11. Remove the power button or power button with optional fingerprint reader.
12. Remove the smart card reader (optional).
13. Remove the speakers.
14. Remove the display assembly (laptop) or display assembly (2-in-1).
15. Remove the SIM card slot filler (for non-WWAN configuration).
About this task
The following images indicate the location of the palm-rest and provide a visual representation of the removal procedure.
Steps
After performing the preceding steps, you are left with the palm-rest.
Removing and installing components
115
To Next Page
Loading...
