Replacing the status-light board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Place the status-light board into the slot on the palm-rest assembly.
2. Adhere the foam that secures the status-light board to the palm-rest assembly.
3. Slide the status-light board cable into the connector on the system board and close the latch to secure the cable.
4. Route the speaker cable through the routing guides on the palm-rest assembly.
Post-requisites
1. Replace the battery.
2. Replace the base cover.
20
Replacing the status-light board 39
To Next Page
Loading...
